Enter a wallet name and device password using the desktop app. The Digital Bitbox will create your first wallet and generate a backup on the micro SD card (SDHC cards are supported). Send coins to the wallet using addresses listed in the 'Receive' tab of the desktop app.
Remember the device password, and keep a copy of it somewhere safe.
Without it, you cannot access your wallet and cannot access the backup saved on the micro SD card.
The backup and device password can be used to recover your wallet. Check out the Backup Center to learn how a backup can be recovered without a Digital Bitbox or to learn how to load your own wallet.
If you would like to use Ether, check this page.
Check your balance and previous transactions.
Talking to device
Talking to blockchain
Mobile app connected
Get addresses to receive coins.
Optionally, use the mobile app to securely verify that the displayed address is correct.
Hold the touch button to approve the transaction.
Optionally, use the mobile app to securely verify that the transaction details are correct.
Manage your wallet here: erase, re-seed, create or load a backup (or import your own wallet), update the device password, connect to a mobile app and enable 2FA (see below), and more.
Use the Digital Bitbox as one member of a multi-signature Copay wallet. The multi-signature wallet co-exists independent of your personal wallet.
Simply initialize the wallet in the free and open source Copay app and enter the invitation code here. No registration is required.
Use a mobile phone as a large screen for securely verifying transactions and receiving addresses created by the Digital Bitbox. This avoids man-in-the-middle attacks on computers that have been fully compromised (i.e. rooted). Optionally in addition, enable the mobile phone as a second-factor authentication (2FA) device using the desktop app's 'Options' tab.
Technically, a private and encrypted communication channel between the mobile phone and the Digital Bitbox is created using a hashed Elliptic Curve Diffie–Hellman (ECDH) key exchange in combination with off-channel information from a blink code, using the Digital Bitbox's LED. All you need to do is count a few blinks and enter them in the mobile phone. See how below.
To begin, your mobile phone and computer need to be connected to the internet. First, connect the mobile app to the desktop app. Then, pair the mobile app with the Digital Bitbox as described below.
Use the mobile app to scan the QR code presented by the desktop app.
Pairing only needs to be done once and can be redone at anytime.
Information received by the Digital Bitbox displays automatically in the mobile when connected to the internet. Otherwise, get the information by scanning QR codes presented by the desktop app.
When full 2FA is enabled, possession of the mobile phone is required in order to spend coins. Full 2FA is enabled using the 'Settings' tab in the desktop app. Under the hood, an encrypted single-use PIN is sent to the mobile app, decrypted there, and returned to the Digital Bitbox when pressing the Accept button.
BE CAREFUL! Be sure to backup your wallet and pair the mobile app before enabling 2FA. Once enabled, the micro SD slot, necessary for backups, and mobile app pairing is disabled. These are re-enabled only after ERASING the Digital Bitbox.